Top 10 Wood Stove Miracle Heat Reclaimer

The US Stove MH8 Heat Reclaimer installs into a 12-inch section of the 8-inch stove pipe just above the stove and has an integrated thermo disk that senses the heat in the chimney. Once hot, the quiet fan blows air through the heat exchanger and brings an extra 10 percent of the heat loss back into the room. Every solid fuel stove loses a large amount of heat through the chimney and flue, and the MH8 Miracle Heat is designed to get a large portion of this heat back.

US Stove’s MH6 Heat Reclaimer has a quiet dependable fan that promotes heat circulation to improve overall efficiency. Every stove or furnace manufactured to date is not totally efficient. This means that heat which could be utilized is going up each and every chimney. The MH6 is designed to utilize a part of that lost heat and yet lets enough heat pass through the chimney so creosote and soot formation is avoided. The heavy-gauge outer box and heat tubes also provide durability and long lasting performance. US Stove has been bringing warmth to homes across the nation for 140-year. US Stove has a wide range of Automatic Circulators, Plate Steel Heaters, Cast Iron Heaters, Pellet/Multi-Fuel Heaters and Gas Fireplaces from which to choose. The large selection of stoves and accessories will ensure warmth of your home with safe, quality products.

Magic Heat is the only UL listed heat reclaimer on the market. Magic Heat reclaims up to 30% of lost heat form your heating appliance and distributes it into your home using only .31 amp of power, roughly equivalent to a 40 watt lightbulb. Magic Heat is designed for heating appliances with inside flue temperatures exceeding 350 degrees and surface temperatures of the single wall pipe below the Magic Heat exceeding 280 degrees. The bottom crimp design makes this unit ideal for wood burning heating applications by containing any creosote within the chimney. A toggle switch allows the 225 CFM fan to operate in two modes, either run continuously or a pre-set thermostat automatically turns the blower fan on when the Magic Heat casing reaches 150 degrees and off at 120 degrees. Magic Heat is easy to install and must be installed between 12 and 24 inches from the appliance flue outlet using single wall connector pipe. How it works: As hot flue gases travel from your heating appliance upward through the flu, they heat the transfer tubes in the inner case. Fresh room air enters thru the back vents and is heated while traveling through the transfer tubes. The 225 CFM fan pushes out the warmed air through the tubes and into your home reclaiming up to 30,000 British Thermal Units (BTU) of lost heat. Flue gases are not restricted and continue up your chimney. Magic Heat is available in 6″, 7″ and 8″ pipe diameters for wood, oil/coal or natural gas burning heating appliances. Manufactured in the USA.

Attaches to stove pipe and reclaims heat normally lost up the flue. Whisper quiet, safety tested UL fan motor gently blows warm air into the room. Thermostatically controlled, turns on at 160 Deg. Fahrenheit, off at 130 Deg. Fahrenheit. Decorative nickel trim.

Set of six – 4 inch diameter stovepipe heat exchanger / radiator rings that extract heat from the hot stove pipe and radiate the heat into the room. They will fit 4 inch stovepipe. (Approximately 13 inch circumference) Easily snapped on, they make close contact with your stove pipe and conduct more usable heat from the hot pipe to be released into the room. Working on the same principle as the aluminum fins on a motorcycle engine, they increase the surface area of the stovepipe between the stove and the chimney, allowing more heat to be radiated and released. You get one lot of 6 radiators. Made of 28 gauge high conductivity aluminum, 1 ½ in wide. They attach quickly and easily to your stovepipe and will work with any heat source. No screws or tools are needed. The ends lock into each other. It takes about 5 minutes to attach all six radfiators. The band loops get nearly as hot as the stovepipe…too hot to touch. FREE HEAT Each 4” diameter radiator has 7 loops that are 2 inch x 1.5 inch. That is 21 square inches of sheet metal. Six rings gives the equivalent of 126 square inches of sheet metal. That is equivalent to a 10 inch x 12 inch sheet of metal. By installing this set of 6 bands, you create the equivalent of a 10 inch x 12 inch sheet of hot sheet metal, 500 – 700 degrees, radiating heat from both sides of the sheet into the room before it escapes out the chimney. That is like a small space heater itself…and it is FREE HEAT. .See my other listings for 3 in, 3.6 insulated, 4 in., 5 in, 6 in, 7 in, and 8 in pipes. Will last a lifetime. They never need maintenance and may be re-used if you replace the old stovepipe. Guaranteed to draw more heat from the stovepipe and pay for themselves in a short time. This set of 6 bands covers a 9 inch length of pipe. Put on as many bands as you wish. NOTE: The length of stovepipe in the picture is not part of the sale.

If you own a free-standing wood stove you need an Ecofan! This unique accessory is designed to sit on top of your wood stove and circulate warm air through the room quickly and efficiently. By creating its own electricity from the heat of your stove, Ecofans do not need household energy or batteries. And unlike noisy built-in blowers, the economical Ecofan is whisper quiet. THE ECOFAN ORIGINAL is the most economical model in the Ecofan family, moving up to 100 cubic feet of air per minute (CFM). It is also the smallest model at 8.5” tall (9.25” with blade) x 5.5” wide x 3” long and comes with a black blade. The Original operates at a stove surface temperature range of 230°F – 650°F (110°C – 345°C).

This is a set of six – six inch diameter stovepipe heat exchanger / reclaimer / radiator rings that reclaim heat from the hot stove pipe and radiate the heat into the room. They fit 6 inch diameter stovepipe. (Approximately 19 inch circumference). They make close contact with your stove pipe and conduct more usable heat from the hot pipe to be released into the room. Just like the fins on a motorcycle engine, they increase the surface area of your stovepipe between the stove and the chimney, allowing more heat to be radiated and released into the room. You get one lot of 6 radiators. They are made of 28 gauge steel, 1 ½ inches wide. They attach quickly and easily to your stovepipe and will work with any heat source.. No screws or tools needed. The ends lock into each other. It takes about 2 minutes to attach all six radiators. The bands conduct heat from the points of contact on the stovepipe to the loops in the band where the heat is released into the room. The band loops get nearly as hot as the stovepipe…too hot to touch. FREE HEAT Each 6” diameter radiator has 10 loops that are 2” x 1.5”…that is 30 square inches of sheet metal. 6 x 30 sq/in = 180 square inches of sheet metal. That is equivalent to a 12” x 15” sheet of steel. So in effect, by installing this set of 6 bands, you create the equivalent of this 12” x 15” sheet of hot sheet metal, 500 – 700 degrees, radiating heat from both sides of the sheet into the room before it escapes out the chimney. That is like a small space heater itself…and it is FREE HEAT. NOTE: ….See my other listing for 3 in, 3.6 in, 4 in, 5 in, 7 in, and 8 inch. They will last a lifetime and never need maintenance. They may be re-used if you replace the old stovepipe. They are guaranteed to draw more heat from the stovepipe. They pay for themselves in a short time. You may put on as many bands as you want to. The more bands, the less heat going out the chimney. NOTE: The length of stovepipe in the picture is not part of the sale.

Set of twelve , 6 inch diameter stovepipe heat reclaimer / radiator rings that reclaim heat from the hot stove pipe and radiate the heat into the room. They make close contact with your stack / pipe to draw more heat out of the pipe. They increase the area of heat dissipation. Heat is conducted into the radiator loops where the heat is transferred into the air. They are widely used as stovepipe heat exchangers that reclaim heat from the hot stove pipe and radiate the heat into the room. You get one lot of 12 radiators. They are made of 28 gauge aluminum, 1 ½ inches wide. They attach quickly and easily to your pipe or exhaust stack. No screws or tools needed. The ends lock into each other. It takes about 10 minutes to attach all twelve radiators. The bands conduct heat from the points of contact on the pipe to the loops in the band where the heat is released. They will last a lifetime. They never need maintenance. They are guaranteed to draw more heat from the pipe. You may put on as many bands as you have room for. One set of 12 bands covers 18 linear inches of exposed pipe. ***PLEASE*** measure your circumference with a flexible tape or string. (Circumference divided by 3.14 = diameter.) See other listings for more sizes. (3, 3.6, 4, 5, 6, 7, and 8 inches) (ALSO SETS OF 6 AVAILABLE) NOTE: The length of pipe in the picture is not part of the sale.

Specification:

Working temperature: 60-350 °C

Speed: 1100rpm

Colour: black

Material: aluminum alloy

Noise: ≦25dB

Dimensions: 5.38 x 7.17 x 4.98 inch (13.5x18x12.5 cm)

Blade diameter: 7.17 inch (18 cm)

The clamps size range: 5-6 inch (12-15 cm)

Type: 4 blades + Bound type

Package Includes:

1x 4 blades stove fan

1x thermometer

Warning:

1.Never handle the base of the stove fan, do not set the stove fan down on an unprotected surface when hot. 

2.To move or carry the fan, always use the extendable handle while wearing gloves. Please keep fan away from small children when in use.

3. The suitable temperature is 60-350 °C. Temperatures above this range may damage the fan and generator set.

Set of six , 3.6 inch dia (3 inch double wall) stovepipe reclaimer / radiator rings that extract heat from the hot stove pipe and radiate the heat into the room. They will fit 3 inch double wall insulated stovepipe (11.5 inch circumference) typically used with pellet and corn stoves. They make close contact with your stove pipe and conduct more usable heat from the hot pipe to be released into the room. They, in effect, increase the surface area of your stovepipe between the stove and the chimney, allowing more heat to be radiated and released into the room. They work on the same principle as the aluminum fins on a motorcycle engine. You get one lot of 6 radiators. They are made of 28 gauge aluminum, 1 ½ inches wide. They attach quickly and easily to your stovepipe and will work with any heat source. No screws or tools are needed. The ends lock into each other. It takes about 5 minutes to attach all six radiators. The bands conduct heat from the points of contact on the stovepipe to the loops in the band where the heat is released into the room. The band loops get nearly as hot as the stovepipe…too hot to touch. FREE HEAT. Each radiator has 6 loops that are 2 inch x 1.5 inch…that is 18 square inches of sheet metal. Six rings gives the equivalent of 108 square inches of sheet metal. That is equivalent to a 10 inch x 10 inch hot sheet of metal.. So, in effect, by installing this set of 6 bands, you create the equivalent of a 10 inch x 10 inch sheet of hot sheet metal, 500 – 700 degrees, radiating heat from both sides of the sheet into the room before it escapes out the chimney. That is like a small space heater itself..and it is FREE HEAT. See my other listing for 3, 4,5,6,7,and 8 inch diameter. They will last a lifetime and may be re-used if you replace the stovepipe. They never need maintenance. Put on as many bands as you wish. This set of 6 will cover a 9 inch length of pipe. . NOTE: The length of stovepipe in the picture is not part of the sale.

Our Promise to Readers

We keep receiving tons of questions of readers who are going to buy Wood Stove Miracle Heat Reclaimer, eg:

• What are Top 10 Wood Stove Miracle Heat Reclaimer for 2020, for 2019, for 2018 or even 2017 (old models)?
• What is Top 10 Wood Stove Miracle Heat Reclaimer to buy?
• What are Top Rated Wood Stove Miracle Heat Reclaimer to buy on the market?
• or even What is Top 10 affordable (best budget, best cheap or even best expensive!!!) Wood Stove Miracle Heat Reclaimer?…
• All of these above questions make you crazy whenever coming up with them. We know your feelings because we used to be in this weird situation when searching for Wood Stove Miracle Heat Reclaimer.
• Before deciding to buy any Wood Stove Miracle Heat Reclaimer, make sure you research and read carefully the buying guide somewhere else from trusted sources. We will not repeat it here to save your time.
• You will know how you should choose Wood Stove Miracle Heat Reclaimer and What you should consider when buying the Wood Stove Miracle Heat Reclaimer and Where to Buy or Purchase the Wood Stove Miracle Heat Reclaimer. Just consider our rankings above as a suggestion. The final choice is yours.
• That’s why we use Big Data and AI to solve the issue. We use our own invented, special algorithms to generate lists of Top 10 brands and give them our own Scores to rank them from 1st to 10th.
• You could see the top 10 Wood Stove Miracle Heat Reclaimer of 2020 above. The lists of best products are updated regularly, so you can be sure that the information provided is up-to-date.
• You may read more about us to know what we have achieved so far. Don’t hesitate to contact us if something’s wrong or mislead information about Wood Stove Miracle Heat Reclaimer.